Canon PowerShot ELPH 140 IS - Manual (Page 100)

100
Before Use
Basic Guide
Advanced Guide
Camera Basics
Auto Mode
Other Shooting
Modes
P Mode
Playback Mode
Setting Menu
Accessories
Appendix
Index
Before Use
Basic Guide
Advanced Guide
Camera Basics
Auto Mode
Other Shooting
Modes
P Mode
Playback Mode
Setting Menu
Accessories
Appendix
Index
No AF frames are displayed and the camera does not focus when the
shutter button is pressed halfway.
• To have AF frames displayed and the camera focus correctly, try composing the
shot with higher-contrast subject areas centered before you press the shutter button
halfway. Otherwise, try pressing the shutter button halfway repeatedly.
Subjects in shots look too dark.
• Set the flash mode to [ h] ( = 56 ).
• Adjust brightness by using exposure compensation ( = 48 ).
• Adjust contrast by using i-Contrast ( = 50 , 71 ).
• Use AE lock or spot metering ( = 49 ).
Subjects look too bright, highlights are washed-out.
• Set the flash mode to [ !] ( = 33 ).
• Adjust brightness by using exposure compensation ( = 48 ).
• Use AE lock or spot metering ( = 49 ).
• Reduce the lighting on subjects.
Shots look too dark despite the flash firing ( =
28
).
• Shoot within flash range ( =
114 ).
•
Increase the ISO speed (
=
50 ).
Subjects in flash shots look too bright, highlights are washed-out.
• Shoot within flash range ( = 114 ).
• Set the flash mode to [ !] ( = 33 ).
White dots or similar image artifacts appear in flash shots.
• This is caused by light from the flash reflecting off dust or airborne particles.
Shots look grainy.
• Lower the ISO speed ( = 50 ).
• High ISO speeds in some shooting modes may cause grainy images ( = 50 ).
Subjects are affected by red-eye ( =
36 ).
•
Set [Lamp Setting] to [On] (
=
38 ) to activate the red-eye reduction lamp (
=
4 )
in flash shots. Note that while the red-eye reduction lamp is on (for about one
second), it is not possible to shoot, because the lamp is counteracting red-eye. For
best results, have subjects look at the red-eye reduction lamp. Also try increasing the
lighting in indoor scenes and shooting at closer range.
• Edit images using red-eye correction ( = 71 ).
Recording to the memory card takes too long, or continuous shooting
is slower.
• Use the camera to perform low-level formatting of the memory card (
=
77 ).
Shooting settings or FUNC. menu settings are not available.
• Available setting items vary by shooting mode. Refer to “Functions Available in Each
Shooting Mode”, “FUNC. Menu”, and “Shooting Tab Menu” (
=
105 – 109 ).
Shooting Movies
The elapsed time shown is incorrect, or recording is interrupted.
• Use the camera to format the memory card, or switch to a card that supports high-
speed recording. Note that even if the elapsed time display is incorrect, the length
of movies on the memory card corresponds to the actual recording time (
= 76 ,
114 ).
[ ] is displayed and shooting stops automatically.
The camera’s internal memory buffer filled up as the camera could not record to the
memory card quickly enough. Try one of the following measures.
• Use the camera to perform low-level formatting of the memory card ( = 77 ).
• Lower the image quality ( = 37 ).
• Switch to a memory card that supports high-speed recording ( = 114 ).
Playback
Playback is not possible.
• Image or movie playback may not be possible if a computer is used to rename files or
alter the folder structure. Refer to “Software Instruction Manual” (
= 86 ) for details
on folder structure and file names.