Canon REALiS SX60 - Manual (Page 93)

93
SE
TTING
UP FU
NCTIO
N
S FROM MEN
U
S
Setting Display Status
Adjusting the Total Number of Dots
[Total dots]
You can select the total number of dots in the
horizontal direction. Adjust the number of dots
when the image distorts or noise is displayed on
the screen at both sides.
T
T
T
Press the [MENU] button when you finish.
Adjusting the Tracking
[Tracking]
You can fine-tune the timing for generating an
image from the image signal. Adjust the tracking
when the image flickers or distorts.
T
T
T
Press the [MENU] button when you finish.
Display settings
Input signal settings
Total dots
Increases the total number of dots.
Decreases the total number of dots.
z Perform this adjustment if the auto PC
adjustment function cannot adjust the
project image correctly.
z The setting is recorded for [ANALOG
PC-1] and [ANALOG PC-2] sepa-
rately.
ANALOG PC
>
<
Display settings
Input signal settings
Tracking
Increases the set value.
Decreases the set value.
z Perform this adjustment if the auto PC
adjustment function cannot adjust the
project image correctly.
z The setting is recorded for [ANALOG
PC-1] and [ANALOG PC-2] sepa-
rately.
ANALOG PC
>
<