Canon EOS C300 - Manual (Page 18)

18
1
Review the access point’s configuration
and then press SET.
The first screen shows the access point’s SSID
and the type of connection. Push the joystick up/
down or turn the SELECT dial to review additional
settings before pressing SET.
2
Save the current configuration.
Select the desired configuration number and then
press SET. You can save up to 5 different network
configuration profiles on the camcorder. If you
select a configuration number that was already in
use, the previous configuration will be overwritten
by the new.
Select [OK] and then press SET. When the
confirmation screen appears, press SET.
Connections via an access point
(Infrastructure): The camcorder will connect to
the network using the configuration just saved.
The icon will appear on the upper left of the
screen, first in yellow while connecting and then in
white when the connection is established. In the
rear panel, the bars of the icon indicate the
strength of the Wi-Fi signal.
AP mode/Ad Hoc connections: After the
icon turns white, the camcorder is ready to
connect directly to the Wi-Fi enabled device.
Perform the following procedure to connect the
device.
Connecting a Device to the Camcorder (AP Mode/Ad Hoc
Connections)
1 On the Wi-Fi enabled device, select the SSID that was set on the camcorder.
In the Wi-Fi settings screen, turn on Wi-Fi and select the Wi-Fi network name entered in
step 3 (A 14).
2 If you selected [WPA2-PSK/AES] for the encryption method, enter the password to
connect the device.
Enter the same encryption key (password) set in step 6 (A 16).
Saving the Configuration
COP
Y