Canon LV-7392A - Manual (Page 72)

72
Appendix
The image is distorted or runs off. – Check PC adjust menu or Screen menu and adjust them.
See pages 33-34, 38-40.
PIN code dialog box appears – PIN code lock is being set. Enter a PIN code (the “1234” or
at start-up. numbers you have set). See pages 22, 60-61.
The Remote control unit does – Check the batteries.
not work. – Make sure no obstruction is between the projector and remote
control.
– Make sure you are not too far from the projector when using the
remote control unit. Maximum operating range is 16.4'(5 m).
– Make sure the code of the remote control unit is conformed to
the projector’s code. See page 59.
– Unlock the Key lock function for the remote control unit
function. See page 60.
Indicator blinks or lights. – Check the status of the projector with referring to "Indicators
and projector Condition". See page 75.
The exclamation mark appears – Your operation is invalid. Operate correctly.
on the screen.
Top control does not work. – The top control is not available if the top control is locked at
Key lock under Security of Setting section. See page 60.
– The projector detects an abnormal condition. Unplug the AC
power cord and contact the dealer where you purchased the
projector or the service center.
WARNING :
High voltages are used to operate this projector. Do not attempt to open the cabinet.
If problems still persist after following all operating instructions, contact the dealer where you
purchased the projector or the service center. Specify the model number and explain about the
problem. We will advise you how to obtain service.
appears on the screen