Canon LV-7392A - Manual (Page 55)

Setting
55
Setting
Enter a Logo PIN code
Use the Point ▲▼ buttons to enter a number.
Press the Point ◄► buttons to fix the number
and move the red frame pointer to the next
box. The number changes to . If you fixed an
incorrect number, use the Point ◄► buttons
to move the pointer to the number you want to
correct, and then enter the correct number.
Repeat this step to complete entering a four-
digit number.
After entering the four-digit number, move the
pointer to Set. Press the OK button so that you
can start to operate the projector.
If you entered an incorrect Logo PIN code,
Logo PIN code and the number () will
turn red for a moment. Enter the correct Logo
PIN code all over again.
Logo PIN code change
Logo PIN code can be changed to your desired
four-digit number. Press the OK button to
select Logo PIN code change. Current logo
PIN code dialog box appears, use the Point
▲▼buttons to enter the correct code. The New
Logo PIN code input dialog box appears. Set a
new Logo PIN code, confirmation box appears,
choose Yes to set the new Logo PIN code.
Be sure to note the new Logo PIN code and
keep it on hand. If you lost the number, you
could no longer change the Logo PIN code
setting.
Use the Point ▲▼ buttons to switch On or
Off, and then press the OK button to make a
choice.
Change the Logo PIN code lock setting
Enter a Logo PIN code
After a correct Logo PIN code
is entered, the following dialog
box appears.
CAUTION:
WHEN YOU HAVE CHANGED THE LOGO
PIN CODE, WRITE DOWN THE NEW
PIN CODE AS A REMINDER. SHOULD
THE LOGO PIN CODE BE LOST OR
FORGOTTEN, THE LOGO PIN CODE
SETTING CAN NO LONGER BE CHANGED.
Change the Logo PIN code lock setting
Change the Logo PIN code
 Note:
If you forget your Logo PIN code and unable to
change it, the Logo PIN code can be reset to the
factory default setting (4321) according to the
following procedures.
When you reset the Logo PIN code, the PIN code and
Key lock will be reset, as well.
1. Unplug the AC Power Cord from the AC outlet.
2. Hold down the OK button on the projector and
connect the AC Power Cord into the outlet
again. Keep holding down the OK button until
the POWER indicator lights. The Logo PIN code
returns to the factory default setting while the Logo
PIN code lock state will remain the same as the
previous set state.