Brother HL-S7000DN - Manual (Page 21)

21
For Wireless Network Users
Wirele
ss Network
f
Temporarily connect the USB cable (not
included) directly to the computer and the
machine.
g
Do one of the following:
 If the Installation confirmation screen
appears, check the box and click Next,
go to
h.
 Otherwise, go to i.
h
Check Yes if you want to connect with the listed
SSID. Click Next and go to
k.
i
The wizard will search for wireless networks
available from your machine. Choose the SSID
that you wrote down for your network in
step
11-a on page 18, and then click Next.
j
Enter the Network Key you wrote down in
step
11-a on page 18, and then click Next.
k
Confirm the wireless network settings and then
click Next. The settings will be sent to your
machine.
l
Disconnect the USB cable between the
computer and the machine and then click Next.
Wireless setup is now complete. A four
level indicator at the top right of your
machine’s LCD will show the wireless
signal strength of your access
point/router.
To install the printer driver, continue to
step 14.
Now go to
step e on page 29
Note
• If the list is blank, check that the access point
has power and is broadcasting the SSID, and
then see if the machine and the access point
are within range for wireless communication.
Then, click Refresh.
• If your access point is set to not broadcast the
SSID you can manually add it by clicking the
Advanced button. Follow the on-screen
instructions for entering the Name (SSID), and
then click Next.
Note
If your network is not configured for
Authentication and Encryption, the ATTENTION!
screen will appear. To continue configuration,
click OK.
Note
• The settings will remain unchanged if you click
Cancel.
• If you want to manually enter the IP address
settings of your machine, click Change IP
Address and enter the necessary IP address
settings for your network.
• If the wireless setup failure screen appears,
click Retry.