beautypg.com

Installing the p-touch editor 3.2 soft- ware – Brother PT-3600 User Manual

Page 33

background image

21

Ch. 2 Getting Started

Ge

tti

ng

S

tar

ted

Memory: At least 32 MB
USB port (installed as standard equipment)
CD-ROM drive

Installing the P-touch Editor 3.2 soft-
ware

The P-touch Editor 3.2 software includes a vari-
ety of more complex functions for printing bar-
codes and images, enabling you to design just
about any label that you can image. Install the
P-touch Editor 3.2 software onto a Macintosh as
described below.

To install the P-touch Editor 3.2 software

1 With the P-touch and the Macintosh turned

off, connect the P-touch to the computer
using the enclosed USB interface cable as
described on page 9. Be sure to leave the
P-touch turned off.

2 Turn on the Macintosh.
3 Insert the enclosed CD-ROM into the com-

puter’s CD-ROM drive.

4 Double-click the Mac OS 9 folder to open

it.

5 Double-click the P-touch Editor 3.2 folder

to open it.

6 Double-click the P-touch Editor 3.2 Installer

icon in the folder that appears. The installer
starts up.

7 Select the installation method.

For a basic installation

Clicking the Install button immediately
starts installing all options.

For a custom installation

Clicking the Custom Install button dis-
plays a dialog box that allows you to
select which options to install.

Only the options with a check mark
beside them are installed. Select the
options that you wish to install, and then
click the Install button.

With a Mac OS before OS X:

NOTE

About 20 MB of available hard-disk space is
needed to begin installation. In order to install all
options, about 100 MB of available hard-disk space
is needed. If enough hard-disk space is available,
click the Install button.

NOTE

In order to print from the P-touch 9600/3600,
“PT-9600/3600 Driver” must be selected for
installation.

If certain options are not installed, some P-touch
Editor functions may not be available.