Brother MFC-230C - Manual (Page 165)

Remote Setup & PhotoCapture Center ®
159
13
c
You can edit a file and save it to another drive on your Macintosh
®
.
d
Quit all applications that are running stored data on the USB Flash memory drive or memory card and
drag the Removable Disk icon into the Trash icon before you remove the memory card from the
machine.
CAUTION
DO NOT unplug the power cord, USB cable or remove a USB Flash memory drive, CompactFlash ® ,
Memory Stick
®
, Memory Stick Pro™, MultiMediaCard™, SecureDigital™ or xD-Picture Card™ from the
machine while it is reading it (when the (PhotoCapture) key is flashing). You could lose your data
or damage the data.
If you take out the memory card while the PhotoCapture key is flashing, you must restart your Macintosh
®
before putting the same media back into the machine. If you do not restart your Macintosh
®
, the data on
your media may be destroyed.
For network users
(For models with built-in network support)
13
a
Put a USB Flash memory drive, CompactFlash
® 1
, Memory Stick
® 2
, Memory Stick Pro™
2
,
MultiMediaCard™, SecureDigital™ or xD-Picture Card™
3
into your machine.
1 This product also supports CompactFlash ® type1.
2 MagicGate Memory Stick ® and Memory Stick Pro™ can be used, but any music data that is stored on the stick cannot be read.
3 This product supports xD-Picture Card™ Type M/Type H.
b Launch any FTP software or any web browser in which FTP is supported. (e.g. Safari, Internet Explorer)
Your browser software accesses the memory card using the FTP protocol and the network Host Name
of the machine. In the address bar, enter ftp://XXX.XXX.XXX.XXX (where XXX.XXX.XXX.XXX is the IP
address of your Brother machine).
Your browser software appears and a list of file names on your memory card is shown.
c Click the name of the file you want to see.