Brother MFC-9330CDW - Manual (Page 39)

Loading paper
25
2
e
Use both hands to push one sheet of
paper or one envelope firmly into the
manual feed slot until the top edge of the
paper presses against the paper feed
rollers. Continue pressing the paper
against the rollers for about two
seconds, or until the machine grabs the
paper and pulls it in further.
NOTE
• If the error message Jam Manual Feed
appears on the Touchscreen, the machine
cannot grasp and pull the paper or
envelope. Reset the machine by
removing the paper and then pressing
Start on the Touchscreen. Reinsert the
paper or envelope and be sure to press it
firmly against the rollers.
• Put the paper or envelope into the manual
feed slot with the side to be printed on
face up.
• When Label is selected in the printer
driver, the machine will feed the paper
from the manual feed slot, even if Manual
is not selected as the paper source.
• Make sure the paper or envelope is
straight and in the correct position in the
manual feed slot. If it is not, the paper or
envelope may not feed correctly, resulting
in a skewed printout or a paper jam.
• Pull the paper or envelope out completely
when you retry putting the paper into the
manual feed slot.
• Do not put more than one sheet of paper
or one envelope in the manual feed slot at
any one time, as it may cause a jam.
f
Send the print data to the machine.
NOTE
Remove each printed page or envelope
immediately to prevent a paper jam.
g
After the Touchscreen shows
Manual Feed , return to step e to load
the next sheet of paper. Repeat for each
page you want to print.
h
(For printing envelopes)
When you have finished printing, return
the two gray levers, that you pulled
down at step b, back to their original
positions.
i
Close the back cover (face-up output
tray) until it locks in the closed position.