Brother MFC-9330CDW User Manual
Page 121
Troubleshooting
107
B
Registration
failed.
Registration failed.
Press
OK
and try again.
Press and hold down
to turn off the
machine.
Wait a few seconds, then turn it on again.
Perform the auto color registration using
the Touchscreen (see Advanced User's
Guide: Auto Registration).
Put in a new belt unit (see Replacing the
belt unit on page 91).
If the problem continues, call Brother
Customer Service.
Rename the File
There is already a file on the
USB Flash memory drive with
the same name as the file you
are trying to save.
Change the file name of the file on the USB
Flash memory drive or the file you are trying to
save.
Replace Belt
It is time to replace the belt
unit.
Replace the belt unit (see Replacing the belt
unit on page 91).
Replace DrumX
1
(
X
) shows drum unit
color that must be
replaced. BK=Black,
C=Cyan,
M=Magenta,
Y=Yellow.
It is time to replace the drum
unit.
Replace the drum unit for the color indicated on
the Touchscreen (see Replacing the drum
units on page 86).
The drum unit counter was not
reset when a new drum was
installed.
Reset the drum unit counter. (see Replacing
the drum units on page 86).
Replace Fuser
It is time to replace the fuser
unit.
Call Brother Customer Service or a Brother
Authorized Service Center to replace the fuser
unit.
To replace Fuser Unit call Brother Customer
Service at:
1-877-BROTHER (1-877-276-8437) (in USA)
1-877-BROTHER (in Canada)
or to locate a Brother Authorized Service
Center, visit us at:
Replace PF kit
It is time to replace the paper
feeding kit.
Call Brother Customer Service or a Brother
Authorized Service Center to replace the
PF Kit.
To replace PF Kit call Brother Customer
Service at:
1-877-BROTHER (1-877-276-8437) (in USA)
1-877-BROTHER (in Canada)
or to locate a Brother Authorized Service
Center, visit us at:
Error Message
Cause
Action