Brother PT-2410 - Manual (Page 99)

95
LENGTH FUNCTION
Although the length of the printed label automatically adjusts to fit the length of the entered
text, there may be times when you will want to make a label with a specific length. The Length
function allows you to set the label length between 1.6 and 11.8 inches (4.0 and 30.0 centime-
ters).
The default length setting is OFF. When the Length function is set to ON, the Length indicator
on the right side of the display lights up.
☞
Turning off the machine and turning it on again changes the length setting back to OFF.
To turn on or off the Length function:
1 While holding down , press once, and keep held down to display the
current length of the label (the text and both margins) briefly, and then display the current
label length setting (ON or OFF).
2 While still holding down , continue pressing until the desired label length set-
ting is displayed.
☞
The Length indicator lights up when ON is selected.
3 Release . If ON was selected, the current label length setting is displayed.
4 Press or to select the desired length or use the number keys to enter the
length.
☞
To change the length in 1” (1.0-cm) steps, hold down either or , and
then release the key when the desired setting is displayed.
The default setting (4” (10.0 cm)) can be selected by pressing
.
To switch the unit of measurement between inches and centimeters, press
until the measurement is displayed in the desired unit.
5 Press .
Code Code
Length
T
Length
T Code Code
Code Code
Length
T
Length
T
Code Code
Home
End
Home
End
Space
Feed&Cut
Space
ñ
M
ñ
M
New Block