Brother PT-2410 - Manual (Page 81)

77
4 Press to engrave the stamp stencil film, and then automatically cut off.
To affix a stamp:
5 Remove the stamp frame from around the stamp film holder ink pad, one side at a
time, then remove the protective seal covering the ink pad and the backing paper
from the stamp stencil film.
6 With the glossy side of the stamp stencil film upward, align one of its ends with the
slit on the side of the stamp film holder.
7 Hold the end of the stamp stencil film in place with your thumb, then pass the tape
through the guides while pulling it tight.
Mirror
Print
1 / 1
C O P I E S Alt
Caps
Width
W O R K I N G Alt
Caps
Width
Length
A.Format
Undl/Frm
Length Length
A.Format
Undl/Frm
Length
Tape end
Glossy side
Slit
Guides