Brother PE-170D User Manual
Page 17
14
1
2
3
3. Guide the thread through the machine and the bobbin
winding guide as marked with the dotted line.
4. Guide the thread through the small hole in the side of the
bobbin from the inside. Holding the thread end, push the
bobbin winder shaft to right.
*
Match the groove of the bobbin with the spring on the shaft.
1
Spring on the shaft
2
Groove in the bobbin
5. Holding the thread end, press the “START/STOP” button.
Wind the thread a few times around the bobbin and press
the “START/STOP” button again.
Trim the excess thread from the top of the bobbin after the
machine stops.
*
It is important to trim the thread close to the spoolend.
6. Press the “START/STOP” button. The machine will stop
automatically when the bobbin is full. Press the
“START/STOP” button to stop at any time or when the
bobbin has stopped moving and the motor is still running.
1
“START/STOP” button
7. Push the bobbin shaft to the left. Remove the bobbin and
continue sewing.
8. Set the bobbin into the shuttle as shown on page 15.
It’s a good idea to have several full bobbins on
hand before start your project.