Brother MFC-J410W - Manual (Page 45)

Scanning
39
2
Reduce Noise
2
You can improve and enhance the quality of your scanned images with this selection. The Reduce Noise
setting is available when using 24bit Color and scan resolutions of 300
 300 dpi, 400  400 dpi or
600  600 dpi.
Brightness
2
Adjust the setting (-50 to 50) to get the best image. The default value is 0, representing an average and is
usually suitable for most images.
You can set the Brightness level by dragging the slide bar to the right or left to lighten or darken the image.
You can also enter a value in the box to set the level.
If the scanned image is too light, set a lower Brightness level and scan the document again. If the image is
too dark, set a higher Brightness level and scan the document again.
Note
The Brightness setting is only available when you set Scan Type to Black & White,
Gray (Error Diffusion) or True Gray.
Contrast
2
You can increase or decrease the contrast level by moving the slide bar to the right or left. An increase
emphasizes dark and light areas of the image, while a decrease reveals more details in gray areas. You can
also enter a value in the box to set the Contrast.
Note
The Contrast setting is only available when you set Scan Type to Gray (Error Diffusion) or True Gray.
When scanning photographs or other images for use in a word processor or other graphics application, try
different settings for the Resolution, Scan Type, Brightness and Contrast to see which setting best suits
your needs.
Document Size
2
Choose one of the following sizes:
 A4 8.3 x 11.7 in (210 x 297 mm)
 JIS B5 7.2 x 10.1 in (182 x 257 mm)
 Letter 8 1/2 x 11 in (215.9 x 279.4 mm)
 Legal 8 1/2 x 14 in (215.9 x 355.6 mm)
(Available on ADF models)
 A5 5.8 x 8.3 in (148 x 210 mm)
 Executive 7 1/4 x 10 1/2 in (184.1 x 266.7 mm)
 Business Card 3.5 x 2.4 in (90 x 60 mm)
To scan business cards, choose the Business Card size, and then put the business card face down at
the top left of the scanner glass.