Brother MFC-J410W - Manual (Page 182)

Remote Setup & PhotoCapture Center ®
176
11
d
Quit all applications that are running stored data on the memory card or USB Flash memory drive and
drag the Removable Disk icon into the Trash icon before you remove the memory card or USB Flash
memory drive from the machine.
CAUTION
DO NOT take out the memory card or USB Flash memory drive while PHOTO CAPTURE is blinking to
avoid damaging the card, USB Flash memory drive or data stored on the card.
If you take out the memory card or USB Flash memory drive while the PHOTO CAPTURE key is flashing,
you must restart your Macintosh at once before putting the same memory card or USB Flash memory drive
into the machine. If you do not restart your Macintosh, the data on your media may be destroyed.
For network users (For models with built-in network support)
11
a
Put a memory card or USB Flash memory drive into your machine.
b Launch any FTP software or any web browser in which FTP is supported.
Your browser software accesses the memory card or USB Flash memory drive using the FTP protocol
and the network Host Name of the machine. In the address bar, enter ftp://XXX.XXX.XXX.XXX (where
XXX.XXX.XXX.XXX is the IP address of your Brother machine).
Your browser software appears and a list of file names on your memory card or USB Flash memory drive
is shown.
c
Click the name of the file you want to see.
Note
Using certain characters or symbols in a file name on the memory card or USB Flash memory drive may
cause a problem accessing the file. We recommend to only use combinations of the following characters
in a file name.
When you take out a memory card or USB Flash memory drive, do the following to prevent damage
to the memory card or USB Flash memory drive:
11
a
Close the browser.
b Wait until the (PHOTO CAPTURE) key stops blinking before taking out the memory card or USB
Flash memory drive.