Brother MFC 8480DN - Manual (Page 65)

Wireless configuration for Windows ® using the Brother installer application (For MFC-8690DW and MFC-8890DW)
54
4
l
If the LCD shows Connected, the machine has successfully connected to your access point/router. You
can now use your machine in a wireless network.
If the LCD shows Connection Error, a session overlap has been detected. The machine has
detected more than one access point/router on your network with the SecureEasySetup™ mode, the
Wi-Fi Protected Setup mode or AOSS™ mode enabled. Make sure that only one access point/router has
the SecureEasySetup™ mode, the Wi-Fi Protected Setup mode or the AOSS™ mode enabled and try
starting from step i again.
If the LCD shows No Access Point, the machine has not detected your access point/router on your
network with the SecureEasySetup™ mode, the Wi-Fi Protected Setup mode or AOSS™ mode
enabled. Move the machine closer to your access point/router and try starting from step i again.
If the LCD shows Connection Fail, the machine has not successfully connected to your access
point/router. Try starting from step i again. If the same message is indicated again, reset the machine
back to the default factory settings and try again. (For resetting, see Restoring the network settings to
factory default on page 123.)
LCD messages when using the SES/WPS/AOSS™ control panel menu
4
LCD shows Connection status Action
Setting WLAN
Searching or accessing the access
point, and downloading settings from the
access point
—
Connecting SES
Connecting WPS
Connecting AOSS
Connecting the access point —
Connected
Connection succeeded. —
Connection Error
Session overlap has been detected.
Check that only one router or access point has
the SecureEasySetup™ mode, the Wi-Fi
Protected Setup mode or AOSS™ mode enabled
and try starting from step i again.
No Access Point
The access point detection failed.
Move the machine closer to your access
point/router and try starting from step i again.
Connection Fail
Connection failed.
1 Try starting from step i again.
2 If the same message continues, reset the
machine back to the factory settings and try
again.