Timeguard SELEKTA 170 top2 - Manual (Page 22)

45
Selection WITH PIN (enter new PIN)
5. Use the + or – key to select WITH PIN.
6. Confirm with the OK key.
7. Create and make note of any desired 4-digit
number.
8. Use the + or – key to select the first digit
of the 4-digit code.
9. Confirm the input digit with the OK key.
10. Select the other digits as described with the + or – key.
11. Confirm in each instance with the OK key. The display
shows FINISH.
12. With the OK key you return back to Automatic mode.
90 seconds after the last key activation, the keyboard lock
engages, i.e. PIN appears. Operation can now only conti-
nue after inputting the correct PIN code.
Selection NO PIN (Remove PIN code)
1. Steps 1. through 4. as before.
2. Use the + or – key to select NO PIN.
3. Confirm with the OK key. The display shows FINISH.
4. You return back to Automatic mode by pressing OK key.
RESET (only in case of emergency)
If you perform a RESET of the timer, the individual
settings will be deleted. The programmed swit-
ching times remain intact.
Note
• If a PIN code has been entered to lock the keyboard,
then it must be input again after a RESET for setting
the clock again.
• Therefore, before performing any RESET operation,
make sure your PIN code is handy.
• If a PIN code has been activated, the timer can no lon-
ger be activated without a valid PIN code after a RESET.
The device must be sent in!
Menu 12. Reset response