NORD Drivesystems BU0710 - Manual (Page 10)

NORDAC SK 700E manual Posicon special extension
10 BU 0710 GB
How to remove the special extension
module :
1. Switch off the mains voltage, wait a few
minutes as directed.
2. Loosen the 2 screws which hold down the
cover grille of the connection area, remove
it, and wedge the device cover out of its
slots, or simply pull it off.
3. Set the locking pin to the "open" position.
4. Use a screwdriver to unlatch the special
extension module (as shown in the figure to
the right) and pull it out completely with your
hand. It may be more convenient to
temporarily remove the customer interface.
5. If you have done so, fit it back into the inverter again.
6. Set the locking pin to
the "closed" position.
7. Reattach all covers.
Customer interface
Special extension
Customer interface
Special extension