Dwyer LCT216 - Manual (Page 10)

Page 10
COUNTER SETTINGS
Parameter configuration
PV SV
FUnC Cont Sets the controller to function as a counter
CntFUn Select the counter to perform single stage counting, two
stage counting, batch counting, total counting or dual
counting.
STAGE1 Controller has a single process value and set point value.
Output 2 will be the same as output 1.
STAGE2 Controller has up to two set point and process values. The
operation is based on the input modes and output types.
bAtCH Controller can be set to count batch processes. In this mode,
the counter will count up until it reaches the set value and then will
increment the batch present value by one. The process will
continue until the batch set point value is reached.
totAL Controller has a single set point. The display can show the
present value since last reset or total counts.
dUAL Controller will either add or subtract the counts from the two
counter inputs.
C inPt Counter input mode can be selected to count up or down when a
counter input signal is received.
UP The present value will increase with each counter input signal.
doun The present value will decrease with each counter input signal.