Tr3 endpoint, Tr3 programming screen, Tr3 endpoint 8 – Badger Meter GALAXY User Manual
Page 8: Tr3 programming screen 8

TR3 ENDPOINT
Figure 6: GALAXY TR3 endpoint
TR3 Programming Screen
The following buttons and fields are included on the TR3 programming screen as shown in Figure 7 on the next page
Buttons
Program
Programs a reading into an RTR endpoint, most commonly after a tamper repair This button is not
active when reading an ADE or HR-E LCD encoder
Start Radio
Starts the endpoint radio
Pause Radio
Pauses the endpoint radio
Stop Radio
Stops the endpoint radio
Force RF
Forces an endpoint transmission
Reading
Tapping the button activates the Reading field
Read Reg
Reads the register of an ADE or HR-E LCD encoder, most commonly to verify a tamper repair This
button is not active when reading an RTR endpoint
Fields
ID/Serial #
Endpoint serial number
Firmware Ver.
Endpoint firmware version
Type
Encoder type
Xmit Intrvl
Radio transmission interval in minutes
Xmit Count
Active count of radio transmissions during the life of the endpoint
NOTE:
N
To perform any of the GALAXY Programmer software functions, remove the cover (PN: 66367-001) of the TR3
endpoint to access the IR port To remove, squeeze the long sides of the cover at the midpoint and pull
GALAXY® Programmer – Handheld Programming Software for TR3 and TR2 Endpoints
Page 8
February 2013