Reading the tr2 endpoint, Magnet swipe, Reading the tr2 endpoint 16 magnet swipe 16 – Badger Meter GALAXY User Manual
Page 16

Reading the TR2 Endpoint
1 On the GALAXY Programmer screen, tap the TR2 IR
tab
Result: The Cable Select screen is displayed, as shown in
Figure 23, reminding you to attach the IR programming
cable to the handheld if you have not already done so.
2 Tap OK
Result: The Wakeup GALAXY screen is displayed,
reminding you to swipe the endpoint with a magnet to
put it in communications mode.
3 Tap OK
Result: The TR2 screen is displayed with the MAGNET
SWIPE message blinking.
Figure 22: TR2 tab
Figure 23: Cable select reminder
Figure 24: Magnet swipe reminder
Magnet Swipe
To put the endpoint in communications mode, hold
the endpoint with the infrared ports in the 12 o'clock
position Then touch the endpoint with the magnet
at the 3 o'clock position and slowly swipe the long
side of the endpoint as shown You should feel a
slight pull from the magnet as you swipe
With a box style endpoint, swipe the magnet along
the side closest to the infrared ports
The endpoint is ready to be read or programmed
The MAGNET SWIPE message does not disappear
from the screen until the read is completed
NOTE:
N
Work quickly The endpoint stays in
communications mode for only a few
seconds after the magnet swipe
Figure 25: Magnet swipe
GALAXY® Programmer – Handheld Programming Software for TR3 and TR2 Endpoints
Page 16
February 2013