Badger Meter GALAXY - Manual (Page 18)

Programming the TR2 Endpoint - RTR only
NOTE: N Programming is for RTR endpoints only If you try to program an ADE endpoint, the reading you enter will be
replaced by an actual reading
1 With the TR2 IR tab selected on the programming
screen, tap the Reading button to activate the field
2 Tap at the end of the current entry in the field Then
use the DELETE key on the keypad to erase the
current entry
Figure 28: Reading field activated
3 Use the keypad to enter the new reading from the odometer on the register
4 Align the optical read head of the IR cable with the IR port of the TR2 endpoint and tap the Program button
Result: The message "Please Wait: Programming" is displayed.
When the message disappears, the endpoint is programmed to start at the reading you entered.
Figure 29: New reading entered Figure 30: Programming in progress
NOTE: N The TR2 endpoint cannot be read or programmed until it has been swiped with the magnet If the Wakeup GALAXY
screen (Figure 24) displays, swipe the endpoint with the magnet and tap the Program button again
GALAXY® Programmer – Handheld Programming Software for TR3 and TR2 Endpoints
Page 18 February 2013