Badger Meter GALAXY - Manual (Page 19)

SETTINGS
On the Settings tab, you can view and change the COM port for the IR cable connected to the handheld
The IR COM port is set to the default of COM1 for both TR2 and TR3 endpoints To change the default setting, follow these
steps, starting from the GALAXY Programmer screen:
NOTE: N Changes to the COM ports should only be made under the direction of Badger Meter Technical Support
1 Tap the Settings tab to open the IR COM Port screen
2 Tap the down arrow (
∨
) or the up arrow (
∧
) to
change the COM Port for the device listed
3 Tap Save to accept the new selection
Tap Cancel to return to the Programmer screen
Tap Exit to leave the GALAXY Programmer software
and return to the Windows home screen
Figure 31: COM port settings
NOTE: N The Built In and Bluetooth fields are not currently in use The boxes should remain unchecked
Programming Manual
Page 19 February 2013