Badger Meter GALAXY - Manual (Page 24)

IR Programming Bracket
An optional IR Programming Bracket (PN: 66632-001) can be used to assist in reading GALAXY endpoints The bracket
facilitates correct alignment between the IR optical read head of the programming cable and the IR port on the endpoint
The IR programming bracket for GALAXY endpoints has two slots that fit the IR programming cables The cable serial numbers
are imprinted on the bracket as shown in Figure 34 The slot has two half circle cut-outs to accommodate the small raised
circles on the label side of the IR head See Figures 36 and 37
The bracket clips on the endpoint when the cover (PN: 66367-001) is removed When the bracket is clipped securely to the
endpoint, it clicks into place and lays flat as shown in Figure 35
Figure 34: IR programming bracket (top view)
Figure 35: Bracket securely clipped to the endpoint (side view)
The images below show the IR head in the slot on the bracket Figure 36 shows the IR head incorrectly inserted on an angle
Figure 37 shows the IR head correctly inserted straight down into the slot
Figure 36: Incorrect placement – arrow shows raised circle on
IR head
Figure 37: Correct placement
GALAXY® Programmer – Handheld Programming Software for TR3 and TR2 Endpoints
Page 24 February 2013