West Control Solutions TB 40-1 Temperature Limiter - Manual (Page 30)

10.1 Resetting to factory setting
In case of faulty configuration, TB40-1 can be reset to ist factory the default con-
dition.
1 For this, the operator must keep the keys increment and decrement pressed du-
ring power-on:
И М
2 For confirmation, press key increment to select YES.
3 Press the key enter to go to the password input.
4 After setting a valid password the factory resetting is confirmed with Enter
and the copy procedure is started (display
COPY).
5 Afterwards the device restarts.
In all other cases, no reset will occur(timeout abortion).
g
If the safety lock is open then factory resetting is not possible.
g
The copy procedure (
COPY) can take some seconds.
Now, the transmitter is in normal operation.
Safety hints
Resetting to factory setting 30 TB40-1
ÌÈ
+ Power on
1 2
И Щ
3 4 5
1.
2.
torY
FAC
°C
°F
Err
no
FAC
°C
°F
Err
YES
FAC
°C
°F
Err
8.8.8.8.
8.8.8.8.
°C
°F
Err
COPY
FAC
°C
°F
Err
PASS
FAC
°C
°F
Err