West Control Solutions MRC 7000 Recorder Manual - Manual (Page 30)

30
Unit Parameters
21 Relay A Assignment rLyA 0=Not assigned 0
1=Assigned to Alarm 1-Pen 1
2=Assigned to Alarm 2-Pen 1
3=Assigned to Alarm 1-Pen 2
4=Assigned to Alarm 2-Pen 2
22 Relay B Assignment rLyb Same selection as rLyA 0
23 Relay C Assignment rLyC Same selection as rLyA 0
24 Relay D Assignment rLyd Same selection as rLyA 0
25 Relay E Assignment rLyE Same selection as rLyA 0
26 Relay F Assignment rLyF Same selection as rLyA 0
27 Relay G Assignment rLyg Same selection as rLyA 0
28 Relay H Assignment rLyH Same selection as rLyA 0
29 Current Output A CurA 0=Not Assigned 0
Assignment 1=Assigned to Process
Value Output-Pen 1
2=Assigned to Process
Value Output-Pen 2
30 Current Output B Curb Same selection as CurA 0
Assignment
31 Current Output C CurC Same selection as CurA 0
Assignment
32 Current Output D Curd Same selection as CurA 0
Assignment
33 Current Output A Range CoAr 0=0-20 mA 1
1=4-20 mA
34 Current Output B Range Cobr Same selection as CoAr 1
35 Current Output C Range CoCr Same selection as CoAr 1
36 Current Output D Range Codr Same selection as CoAr 1
37 Chart Rotation Time Crt 0.1 to 999.0 hours per 1.0
rotation
38 Pen Action on Power Up PAPu 0=Pen(s) go to the "home" 0
position (towards chart
center) when powered up
1=Pen(s) remain in last
position prior to power down
39 Chart Operation Coo 0=Chart continues rotating 0
in Off Mode in the Off mode
1=Chart stops rotating while
in the Off mode
DISPLAY AVAILABLE FACTORY YOUR
STEP DESCRIPTION CODES SETTINGS SETTING SETTING