West Control Solutions MRC 7000 Recorder Manual User Manual
Page 23
23
3.5.3 PROGRAM MODE CONFIGURATION PROCEDURE
The Program mode provides a means to configure or reconfigure the instrument operation
within the limits of the hardware specified and provided. Parameters to be configured will be
only those that are applicable as determined by the hardware provided.
Review the configuration procedures in Table 3-2 (page 28). Use the "Your Setting" column
in the table to record your selections.
3.5.3.1 ENTERING THE PROGRAM MODE
Press and release the SCROLL key until Prog is displayed. This is the mode code for the
Program mode. With Prog displayed press the DOWN key to enter the Program mode. If the
Prog code does not appear refer to Table 3-1 (page 24) for Enable mode instructions.
3.5.3.2 MOVEMENT IN THE PROGRAM MODE
Each time the DOWN key is pressed while a parameter code is being displayed , such as
dFF, another parameter code will be displayed. Press the SCROLL key with a parameter
code displayed to view the parameter value selected. Use the UP or DOWN keys to change
the parameter value as desired for the application. Pressing the SCROLL key with a parame-
ter value displayed will cause the next parameter code to be displayed.
Depressing the UP key while a parameter code is displayed will exit the program mode and
the Prog code will appear in the display. Use the SCROLL key to proceed to any other mode.
3.5.3.3 ONE PEN INSTRUMENTS
For instruments specified and provided with only one pen, all configuration and operating
parameters and values will appear in the upper display which is dedicated to Pen 1. This is
the only display provided.
3.5.3.4 TWO PEN INSTRUMENTS
Instruments specified and provided with two pens require configuration of each pen. Configu-
ration of the Program mode is broken into three parts; First, the parameters that are associ-
ated with Pen 1 will be displayed in the upper display . Next, the Program mode parameters
associated with Pen 2 will be displayed in the lower display . Finally, parameters that are
common to both pens, such as chart rotation speed, will be displayed for configuration in the
upper display. Access to either the Pen 1, Pen 2 or Unit (common) parameters may be quickly
obtained by depressing the Down key with Prog displayed. The display will be PEn1, press
and release the SCROLL key and display will sequence the PEn2 , unit and PEn1 codes.
Press the DOWN key to enter the section of the Program mode desired.
3.5.3.5 PROGRAM MODE CONFIGURATION
Refer to Table 3-1 (page 24) for configuration procedures for the Program mode. All possible
parameters are shown for illustration purposes. Only those parameters applicable to each
respective pen will actually be shown.
3.5.4 ALARM SET MODE CONFIGURATION PROCEDURE
The Alarm Set mode allows the entry, review or altering of the alarm setting(s). Parameters to
be configured will be those that are assigned in the Program mode.
Review the entry procedure and the configuration procedures in Table 3-3 (page 32). Use
the "Your Setting" column in the table to record your programming.
3.5.4.1 ENTERING THE ALARM SET MODE
From the Operate or Off mode, press and release the SCROLL key until ASEt is displayed.
This is the mode code for the Alarm Set mode. With ASEt in the display , press the DOWN
key to enter the mode. If the ASEt code does not appear refer to Table 3-1 (page 24) for
Enable mode instructions.