Warren Controls PICV Series - Manual (Page 3)

3
PRESSURE INDEPENDENT CONTROL VALVE PICV_IOM_REVF_0114
DPRV DOUBLE ACTING DIAPHRAGM ACTUATOR WITH SPRING ASSIST
Control Signal: Differential Pressure from Control Valve,
2.0 to 8 PISG (0.14 to 0.55 BARD)
150 PSIG (10.3 BARD) Max Static
Fluid: Chilled Water Typical, Water or Water/Glycol from 35 °F- 180°F (2°C - 82°C )
Spring Pack: Low DP Spring: Adjustable 2 to 6 PSIG (0.14-0.41 BARD)
Medium DP Spring: Adjustable 5 to 8 PSIG (0.34-0.55 BARD)
Construction: Cast Gray Iron Class G3000, epoxy coated, epoxy coated spring, SS components, Woven Buna-N, nylon reinforced.
Temperature Limits: Ambient 32°F - 122°F ( 0°C - 50°C )
Mounting: Factory Aligned, Vertical Above Centerline of Control Valve
Consult factory for preconfigured alternate orientations
ELECTRIC ACTUATOR SPECIFICATIONS (TR5000-X)
Valve Usage: 5, 6, 8, & 10 inch, DN125, DN150, DN200, DN250
Control Signal: 4-20 mAdc (Factory Setting), 0-10 Vdc, 2-10 Vdc, or 0-20 mAdc; Field Selectable (Dip Switch)
Control Action: Direct Acting, Actuator Shaft Extends on Increasing Signal (Factory Setting) or
Reverse Acting, Actuator Shaft Retracts on Increasing Signal; Field Selectable (Dip Switch)
Power Supply: 220 VAC
Power Consumption: 12VA
Timing: 90.68 Seconds / Inch (3.57 s/mm)
Feedback Signal: 4-20 mAdc (Factory Setting), 0-10 Vdc, 2-10 Vdc, or 0-20 mAdc
Field Selectable (Dip Switch); Feedback Signal Increase as Actuator Shaft Extends (Factory Setting) or Feedback
Signal Increases as Actuator Shaft Retracts; Field Selectable (Dip Switch)
Failure Mode: Fail Actuator Shaft Retracted on Loss of Signal (Factory Setting) or Fail Actuator Shaft Extended on Loss of Signal
Field Selectable (Dip Switch); Actuator Shaft Fails In Last Position on Loss of Power
Manual Override: Yes
Construction: Die Cast Aluminum Motor Housing & Yoke. Painted.
Case Has Two PG11 Cable Glands Accepts 0.197 to 0.394 inch (5mm to 10mm) Diameter Cable
Connections: Coded Screw Terminals
Locations: NEMA Type 3 / IP54
Temperature Limits: Ambient 14˚F to 122˚F ( -10˚C to 50˚C )
Relative Humidity: < 95% RH (40ºC)
Mounting: Factory Aligned, Vertical Above Centerline of Control Valve; Consult factory for preconfigured alternate orientations
4X 0.31 in (0.79 cm) THRU MOUNTING FOOT
8.75 in (22.23 cm)
6.69 in ( 16.99 cm)
6.72 in
(17.O7 cm)
4.91 in
(12.47 cm)
6.97 in
(17.7O cm)
5.19 in
(13.18 cm)
1/2 in (1.27 cm)
8.5 in (21.59 cm)
VMS-25 BCM