Thermo Fisher Scientific CyberScan CON 510 - Manual (Page 19)

Instruction Manual CON 510
SETUP
.
P5.0: Mode of Calibration
Selection of Automatic or Manual Calibration
(only in Conductivity mode)
Selection of Single or Multi-point Calibration
SETUP
.
P6.0: Selecting cell constant
Selecting cell constant K: 0.1, 1.0, 10.0
SETUP
.
P7.0: Reset to factory defaults
Reset meter to factory defaults
CAL
.
CAL
uS
SETUP
.
SETUP
CAL
.
uS
SETUP
CAL
.
SETUP
ENTER
RANGE
CAL
MEAS
CAL
MEAS
7.2 P1.0: Viewing Calibration Data
This mode lets you recall previous calibration data of Conductivity/TDS. This is for
viewing only and no changes can be made.
1. From measurement mode, press SETUP key to enter into setup [SETUP] mode.
2. Use
MI/▲ or MR/▼ to scroll through sub-menus until you view main-menu CAL
P1.0 on the display.
3. Press ENTER repeatedly to view all previous calibration data, starting from the first
range till fifth range. The meter will display the calibration value of that particular
range provided calibration is performed. If any of range is not being calibrated the
upper display shows “---“.
4. When you have scrolled through all calibration data, you will automatically return to
the SETUP main-menu P1.0. Press CAL/MEAS key if you wish to return to
measurement [MEAS] mode. Or to exit from viewing of any range in respective sub-
menus, press CAL/MEAS key reverts to the SETUP main-menu P1.0.
NOTE: If you enter into the setup mode from Conductivity measurement mode,
calibration data will be in μS or mS. Similarly if you enter into the setup mode from TDS
measurement mode, calibration data will be in ppm or ppt.
15