Techne Prime Elite - Manual (Page 57)

55
CURRENT STATUS
The Current Status area of the Home Screen provides status information on the Prime Elite and any
connected Satellite units.
On the Home Screen, the Current status area
shows the versions of software and firmware loaded
on the unit.
• Touch the Current status button to view the
status of the Prime Elite and any connected
units.
The Prime Elite and any satellite units connected to
it will be listed. The ID shows the serial number of
the unit in brackets and for Satellite units the ID
number allocated in square brackets.
If a unit is running a program, as shown by the
status, the Run Screen can be viewed. Runs can
then be paused or stopped as required.
• Touch the area to select the required unit.
• Touch View.
• Touch Cancel to return to the Home Screen.
Reset Satellite IDs
When first connected, a Satellite unit is allocated an
ID number by the Prime Elite. The ID numbers can
be reset following the instructions given below.
• Remove the USB cables from the rear of the
Satellite units.
• Touch Reset Satellite IDs.
• During the next 120 seconds, re-insert the USB
cables in the order you wish the Satellite IDs to
occur.
• When done, touch OK.