Techne Prime Elite - Manual (Page 28)

26
The temperature value will now appear orange in
the programming screen indicating that it contains a
modified function.
Note: It is not possible to both increase and
decrease the temperature of the same step.
To enter a temperature gradient on a step:
• Touch the button below Temperature Gradient
to turn this function on. Next touch the
temperature entry button below this.
A new screen will open which is similar to the
simple temperature entry screen. The maximum
temperature gradient (based on the set hold
temperature and the temperature limits of the unit)
will be shown.
• Enter the required value.
• Touch DEL to clear the entry.
• If an entered gradient temperature is invalid, a
prompt will indicate the acceptable range.
• Touch OK to return to the previous screen. The
temperature gradient for the step will now be
displayed.
• Touch OK again to return to the programming
screen.
• Touch Cancel to return to the programming
screen if no changes are required.