Techne TC-5000 - Manual (Page 43)

42
This screen is displayed if there is a power loss
during the running of the program and the
auto-restart function is switched on. The
display shows the times at which the power
failed and resumed.
The "Show Info" button takes the screen
back to the program information and display.
When the program has finished or been
stopped then the instrument will perform its
normal start-up tests.
Program
100
50
0
00h01m 00h02m 00h03m 00h04m 00h05m
B ACTIN
Auto Restart
Off 15/05/2006 10:21:28
On 15/05/2006 10:21:36
Pause Show Info Stop
Set program defaults
Heated lid Disabled
Heated lid before program Off
Pause before program Off
Initial denaturation Disabled
Hot Start Disabled
Exit
▼ ▼
Techne
TC-5000
Program
Defaults
Programs
Gradient
Calculator
Exit
To access all the parameters it is necessary to
move up and down the menu using the
cursor arrows. The parameters which can be
edited are:
Heated lid: Select the "Heated Lid" and then
in the temperature editing window it is
possible to enable/disable the heated lid. If
"Enabled" is pressed the text changes from
xxxxx to allow a temperature to be typed in.
The lid can be programmed between 100 and
115°C.
Heated lid before program: Selecting this
option simply moves between On and Off.
This option ensures that the heated lid is at
the correct temperature before starting the
actual program.
PROGRAM DEFAULTS
It is possible to change the pre-defined parameters which are used for every program by editing the
Program Defaults. This information can be found in the System User menu.