KROHNE BW 25 EN - Manual (Page 27)

START-UP
5
27
BW25
www.krohne.com 09/2010 - 4000432302 MA BW25 R05 en
Start-up
5.1 Start-up
5.2 Indicator M10
Start
After the device is switched on, the display shows the following in sequence
• "Test",
• the device type and
• the version number.
Afterwards the device performs a self-test and switches to measurement mode. Here all of the
parameters preset for the customer are analysed and checked for plausibility, and the current
measured value is displayed.
Operation
CAUTION!
When starting up the device, the following points must be observed:
• Compare the serial number on the indicator (nameplate) with the serial number on the
displacement rod, the pressure sleeve and the flange.
• Avoid assembling components that have different serial numbers.
• Ensure material compatibility of the wetted parts.
• The indicator system has been factory set such that when the displacement rod is not
immersed (empty tank) the indicator shows "0" at an operating temperature of 20°C.
• Do not change the factory setting of the pointer. This applies in particular where high
pressures and high temperatures are involved.
INFORMATION!
The device is always preset for the user and his application.
INFORMATION!
The device is low-maintenance
Comply with the application limits with regard to temperature of the medium and ambient
temperature.
MA_BW25_R05_en_432302_PRT.book Page 27 Tuesday, September 28, 2010 8:17 AM