KROHNE BW 25 EN - Manual (Page 13)

INSTALLATION
3
13
BW25
www.krohne.com 09/2010 - 4000432302 MA BW25 R05 en
Installation
3.1 Notes on installation
3.2 Storage
• Store the device in a dry and dust-free location.
• Avoid lasting direct exposure to the sun.
• Store the device in its original packing.
• The permissible storage temperature for standard devices is -40...+80°C / -40...+176°F.
3.3 Installation condititions
INFORMATION!
Inspect the cartons carefully for damage or signs of rough handling. Report damage to the
carrier and to the local office of the manufacturer.
INFORMATION!
Check the packing list to check if you received completely all that you ordered.
INFORMATION!
Look at the device nameplate to ensure that the device is delivered according to your order.
Check for the correct supply voltage printed on the nameplate.
CAUTION!
When installing the device, the following points must be observed:
•
Before installation, compare the serial number of the display (nameplate) with the serial
number on the displacement rod, the flange and the magnet.
• In the case of level displays with a bypass chamber, the BW25 serial number on the bypass
chamber should be compared with the serial number on the display.
• Avoid combining parts with differing serial numbers.
• Ensure the material compatibility of the parts in contact with the product.
• Screws, bolts and gaskets are to be provided by the customer and must be selected in
accordance with the pressure rating of the mounting flange or the operating pressure.
• Align the gaskets. Tighten the nuts with the tightening torques of the appropriate pressure
rating.
• Do not lay signal cables directly next to cables for the power supply.
MA_BW25_R05_en_432302_PRT.book Page 13 Tuesday, September 28, 2010 8:17 AM