KROHNE PipePatro EN - Manual (Page 37)

OPERATION
3
37
PIPEPATROL
www.krohne.com 02/2013 - 4002275001 - MA PipePatrol R01 en
3.6.2 Application alarm
In some cases it could happen that the current system conditions lead into a system failure. If
this happens, the leak detection will stop and raise an application alarm shown in the "Main
State" box of the "Status Window".
After pressing the button (2), the system performs a restart and goes into the "Stop" mode. The
operator has to set the system back online (for details refer to
Stop and start the LDS on page
36).
CAUTION!
Weather this malfunction occures, contact the manufacturer immediately to check-up the
system!
Figure 3-15: Application alarm and reset of this alarm
1 "Main State" box with the application alarm
2 Select "Reset SW-Alarm" to reset the system and afterwards "close" the dialogue box