KROHNE PipePatro EN - Manual (Page 36)

3
OPERATION
36
PIPEPATROL
www.krohne.com 02/2013 - 4002275001 - MA PipePatrol R01 en
3.6 LDS system commands
3.6.1 Stop and start the LDS
It may be required from time to time to stop the LDS and then to put it back online again. This can
be done from each screen by clicking on "Main State" in the "Status Window" of the selected
system.
Only the currently possible commands will be enabled (i.e. if the system is online therefore only
"Stop" is enabled).
• Stop Stop Stop Stop
Stops the LDS for the current pipeline.
• Online Online Online Online
Starts the LDS for the current pipeline.
• Reset SW-Alarm Reset SW-Alarm Reset SW-Alarm Reset SW-Alarm
Resets an application alarm that has been raised for a pipeline (for details refer to
Application alarm on page 37).
Figure 3-14: LDS commands
1 "Main State" box to control the system
2 Select "Stop" to stop the system and afterwards "close" the dialogue box
INFORMATION!
Each of the displayed pipelines can be stopped separately.