KROHNE OPTIFLEX 2200 C_F Quickstart EN - Manual (Page 5)

INSTALLATION
2
5
OPTIFLEX 2200 C/F
www.krohne.com 08/2013 - 4000622103 - QS OPTIFLEX 2200 R03 en
2.1 Intended use
This TDR level transmitter measures distance, level, mass and volume of liquids, pastes,
slurries, granulates and powders.
It can be installed on tanks, silos and open pits.
2.2 Scope of delivery
CAUTION!
Responsibility for the use of the measuring devices with regard to suitability, intended use and
corrosion resistance of the used materials against the measured fluid lies solely with the
operator.
INFORMATION!
The manufacturer is not liable for any damage resulting from improper use or use for other than
the intended purpose.
INFORMATION!
Do a check of the packing list to make sure that you have all the elements given in the order.
Figure 2-1: Scope of delivery
1 Signal converter and probe.
2 Probe segments. For the assembly procedure of the single rod probe, refer to the instructions that are supplied with
the device. If a single rod or coaxial probe is attached and you ordered the "segmented probe" option, only part of the
probe is attached to the device. For the assembly procedure of the segmented single rod probe, refer to
How to as-
semble the single rod probe (segmented probe) on page 20, refer to the instructions that are supplied with the device.
For the assembly procedure of the segmented coaxial probe, refer to the instructions that are supplied with the device.
3 Quick Start
4 DVD-ROM. This contains the Handbook, the Quick Start, the Technical Datasheet and related software.
5 Strap wrench
6 Probe assembly cover
INFORMATION!
No training required!