KROHNE OPTIFLEX 2200 C_F Quickstart EN - Manual (Page 23)

INSTALLATION
2
23
OPTIFLEX 2200 C/F
www.krohne.com 08/2013 - 4000622103 - QS OPTIFLEX 2200 R03 en
2.10.3 How to assemble the segmented coaxial probe
CAUTION!
Make sure that the length of the probe is correct. If the probe is too long, refer to "How to
decrease the length of probes" in the handbook.
Figure 2-25: Equipment needed to assemble the coaxial probe
1 Converter and process connection
2 HC M4×20 screws (1 screw per probe segment)
3 Lockwashers (1 pair of washers per probe segment)
4 Top (quantity: 1), middle (quantity: 1 or more) and bottom (quantity: 1 - with 1 socket set screw M5×5) segments of the
signal rod
5 PTFE spacer (1 spacer per probe segment)
6 Middle (quantity: 1 or more) and bottom (quantity: 1) segments of the coaxial tube
7 Union nut with 2 socket set screws M5×5 (1 union nut per segment of the coaxial tube)
8 Tools: two 7 mm open-end wrenches (not supplied)
9 Tools: two pipe (Stillson) wrenches (not supplied)
10 Tools: one 2.5 mm Allen wrench and one 2 mm Allen wrench (not supplied)