GW Instek PEL-3000 Series Quick Start Guide - Manual (Page 12)

Power Up
1. Insert the AC power cord into the power socket.
2. Turn the power switch on
from the rear panel.
(O → —)
3. If the unit doesn’t turn on, press the ON/STBY
key on the front panel.
 The ON/STBY key will go from standby
(red) to ON (green).
4. The unit will show the splash screen and then
load the settings from when the unit was last
powered down.
Load Default Settings
When first using the PEL-3000, recall the factory
default settings to ensure the unit is in a known state.
See the user manual for a list of the default settings.
1. Press
Shift
+
File
FUNC
.
2. Select Media/Default [F1].
3. Select Factory Default [F2].
4. Press Factory Default [F2] again to confirm.