Fire-Lite LCD-80FC Remote Fire Indicator - Manual (Page 15)

LCD-80FC Instruction Manual — P/N 53244:B 5/13/2013 15
Surface Mount Backbox Mounting
3.3 Surface Mount Backbox
Remove the plug-in terminal blocks from the LCD-80FC circuit board. Connect the EIA-485 and
power wiring into the terminal block positions illustrated in Sections 4.1 and 4.2. Plug the terminal
blocks back into the P2 and P1 connectors on the back of the indicator circuit board. Set DIP
switch SW1 for the desired options. Refer to Figure 2.2 on page 9.
Carefully insert the LCD-80FC into the three-gang electrical box and attach it using the four
mounting holes on the LCD-80FC flange and the four screws provided for this purpose. Replace
the trim ring and secure with the two screws which were previously loosened. Do not overtighten.
Local
Silence
Lamp
Test
Hold 3 sec.
LCD-80FC flange
Mounting holes (4)
The LCD-80FC can be surface mounted in a
three-gang electrical box, P/N SBB-3 or
equivalent, with a minimum depth of 2.75".
LCD-80FC Three-gang surface box P/N SBB-3
flange
EIA-485 and power wiring
LCD
80
fc
flg
.w
mf
Sbb
-3.w
m
f
L
cd4
0b
o
x.
w
m
f
Figure 3.5 Surface Mounting