Detcon 700 Series Remote Sensor/Alarm Relay Module With HART Interface - Manual (Page 21)

700 HART-RAM I.M.
Figure 13 FP Configuration Setup
This screen will vary depending on the type of Model 700 sensor attached to the HART-RAM. The Range
Set up will display the Model Type of the sensor, followed by the PV LRV (Primary Variable Lower Range
Value) and the PV URV (Primary Variable Upper Range Value), and the Conc Units (Concentration Units),
the display may also show the Sensor Range. The Sensor Setup portion of the screen will display sensor
specific parameters:
DM
• Sensor Range
• Cell Bias
• Gain Code
• Raw Counts
• Sensor Life
FP
• Gas Factor
• Cal Factor
• Bridge Current
• Bridge Voltage
• Sensor Life
IR
• Gas Factor
• Active Counts
• Reference Counts
• Range Multiplier
• Sensor Life
PI
• Sensor Range
• Gain Code
• Raw Counts
• Zero Offset
• Sensor Life
700 HART-RAM I.M. Rev. 0.0 Page 17 of 24