Detcon 700 Series Remote Sensor/Alarm Relay Module With HART Interface - Manual (Page 16)

700 HART-RAM I.M.
6. HART Operator Interface
The HART-RAM provides the ability to interface with the sensor via the HART Interface. The HART
interface Host can be a PC, a Laptop, or several handheld devices such as the Emerson 375 Field
Communicator. Although the displays on each device may be different and the menu names may change, the
information provided should be the same. The HART Interface consists of three basic Menus, each with a
subset of menus or screens:
Device Variables Menu
Primary
Variables
Identification
Diagnostics Menu
Device
Status
Sensor Status
Device Status Menu
Configuration
Setup
Calibration
HART
Setup
Note: The screen shots shown below are taken from the HART Communication Foundation SDC625
Reference Host. The user’s screen appearance may be different depending on the HART host used.
6.1 Device Menu
6.1.1 Primary Variables
The primary Variable Screen contains the basic information from the sensor and is broken into four basic
sections. None of these variables are changeable, and are directly read from the sensor.
Figure 10 Primary Variables
700 HART-RAM I.M. Rev. 0.0 Page 12 of 24