DeFelsko PosiTector 6000 v.7.3 Full Manual - Manual (Page 18)

15
Gage Info
Displays the model number & serial number, probe type & serial
number, PosiSoft.net registration key, the amount of remaining
memory for storage of readings, date and time, and software
packages.
For security purposes, the registration key is required to add the
Gage to your free PosiSoft.net account.
Increases the displayed Gage resolution as follows:
Hi Res
ü
Resolution Range
0.01 mil 0.00 - 99.00 mils
0.1 mil 100.0 - 999.9 mils
0.1 um 0.0 - 999.9 um
1.0 um over 1000 um
Gage accuracy is not affected. NOTE:
Increases measurement speed for most probes. Useful for quick
inspection or when measuring large areas with thick coatings
where proper probe positioning is not critical. Swift up/down probe
movement is required. Reduced accuracy may be noted.
In ordinary operation, the PosiTector 6000 takes thickness
measurements every 2 seconds when placed onto a surface.
Normally, the user raises the probe after it has taken a single
measurement and relocates it to a second location. Scan mode
modifies this behavior in two ways. First, measurements are taken
much faster. Second, all measurements are recorded when
memory is on. As the probe slides along the surface in scan mode,
the PosiTector 6000 takes single measurements in quick
succession. This may reduce the life of the probe. Recommended
for smooth surfaces only.
Scan
ü
Fast
ü
(Advanced models only)