Star Water Systems S1104 - Manual (Page 3)

3
© Copyright 2004. All rights reserved.
11 3/8"
WEEP HOLE
WEEP HOLE
DISCHARGE PIPE
PUMP DISCHARGE
X (4" MIN.)
SEE NOTE
PIPING SHOWN ONLY
FOR CLARITY.
STEP 1 Determine Installation Confi guration
Figure 1.1A
INTERNAL TRAP
NOTE: The basin is designed to be installed directly under the sink (Internal Trap) or on the side (standard)
Check local and state codes before using the internal trap option.
1.1) Figure 1.1A and 1.1B are typical confi gurations for installation of the drain systems. The actual confi guration
will vary depending on your cabinet and sink confi guration.
NOTE: If installing the internal trap, record the “x” dimension, it will be required in Step 4.
INTERNAL TRAP COMPONENTS SUPPLIED BY OTHERS.
STEP 2 Install the Discharge Pipe onto the Pump
Figure 2.1
Figure 1.1B
STANDARD (EXTERNAL TRAP)
SK2001
SK2022
BE SURE THAT WEEP
HOLE IS NOT DIRECTED TOWARD THE
FLOAT!
Water stream will be visible from this
hole during pump run periods.
IMPORTANT!
IMPORTANT!