Star Water Systems COND1 User Manual

Page 5

4.1) The pump safety switch should be used on 24V Class II control circuits only. The pump safety switch connections

are available on standard 1/4 in. quick connect terminals located on the top cover. Two wires with pre-crimped

connections may be plugged onto the COMMON and RUN terminals and wired into the 24 Volt thermostate

circuit to shut off A/C systems should an overflow condition occur. The safety switch operate with or without

power provided to the pump.

Figure 4.1

Note: Do not use flexible tubing larger than 3/8” ID. A hose clamp (not included) is recommended.

3.1) Extend the discharge pipe, from the barbed check valve, to the highest point possible. Refer to Figure 3.1

3.2) From this point, direct the discharge line to the location of the main drain, maintain a continuous downward

slope.

Note: If a continuous downward slope is not possible, then make an inverted “U” at the highest point of the discharge

line.

Note: Make sure the 3/8” ID tube is supported in a way it will not “Kink or Pinch off” blocking flow.

Figure 3.1

Sk1764

Sk1766

STEP 3

Installation of Discharge Line

STEP 4

Installation of Safety Switch

(RECOMMENDED, NOT NCLUDED)

GFCI Outlet

Pipe Supports

To Main Drain

Floor Joists

HOSE CLAMP

3/8" D Tubing

15 FT

Max.

Inverted "U"

Note: Condensate Drain Lines

not Shown. Refer to Step 2 for

Installation of Drain Lines.

INLETS (4)

DISCHARGE FITTING

SAFETY SWITCH CONNECTORS

OPERATION LIGHTS

POWER CORD

(2) 1/4" QUICK CONNECT

TERMINALS

SK1767