beautypg.com

Star Water Systems COND1 User Manual

Page 4

background image

4

© Copyright 2012 Star Water Systems. All rights reserved.

1.1) Select a location for the pump that is below the evaporator drain and/or furnace drain.

1.2) The unit has two brackets built into the deck so that it can be installed to the wall or side of the appliance.

Refer to Figure 1.2.

2.1) To prevent pipe blockage, modify the end of the pipe or tubing as shown in Figure 2.1.

2.2) Plumb, flexible tube or pipe, from the condensate drain and/or from the furnace drain to the inlet hole(s) on

the pump. Refer to Figure 2.2.

Figure 1.2

Figure 2.2

Figure 2.1

Note: The drain line(s) should have a continuous downward slope to allow for gravity flow.

Note: Local codes may require the use of a condensate neutralizer when using this pump.

Note: Make sure the drain lines from the A.C. condenser are supported above the reservoir and no weight from the

drain line is directed to the bottom of the reservoir.

Sk1762

STEP 1

Mounting Location

STEP 2

Installation of Condensate Drain Lines

SK1762

CONDENSING GAS

FURNACE

OVERFLOW

MAIN CONDENSATE DISCHARGE

CONDENSATE TRAP

GFCI

OUTLET

MOUNTING BRACKETS

SK1765

Drain Pipe

45°

SK1763

CONDENSING GAS

FURNACE

A/C CONDENSER

MAIN DRAIN FROM COIL

OVERFLOW DRAIN FROM

COIL WHEN REQUIRED

GFCI

OUTLET

MAIN DRAIN FROM FURNACE

CONDENSATE NEUTRILIZER

CARTRIDGE (IF REQUIRED)

OVERFLOW DRAIN

FROM FURNACE

Note:Insert, tubing

or pipe, through

the inlet until the

tip contacts bottom

of reservoir.