Star Water Systems COND1 - Manual (Page 2)

2
© Copyright 2012 Star Water Systems. All rights reserved.
This product is warranted for one year from the date of purchase or two
years from the date of manufacture, whichever occurs first. Subject
to the conditions hereinafter set forth, the manufacturer will repair or
replace to the original consumer, any portion of the product which proves
defective due to defective materials or workmanship. To obtain warranty
service, contact the dealer from whom the product was purchased. The
manufacturer retains the sole right and option to determine whether to
repair or replace defective equipment, parts or components. Damage due
to conditions beyond the control of the manufacturer is not covered by
this warranty.
THIS WARRANTY WILL NOT APPLY: (a) To defects or malfunctions
resulting from failure to properly install, operate or maintain the unit in
accordance with printed instructions provided; (b) to failures resulting
from abuse, accident or negligence or use of inappropriate chemicals or
additives in the water; (c) to normal maintenance services and the parts
used in connection with such service; (d) to units which are not installed
in accordance with normal applicable local codes, ordinances and good
trade practices; and (e) the unit is used for purposes other than for what it
was designed and manufactured.
RETURN OF WARRANTED COMPONENTS: Any item to be repaired
or replaced under this warranty must be returned to the manufacturer at
Kendallville, Indiana or such other place as the manufacturer may desig-
nate, freight prepaid.
Limited Warranty
THE WARRANTY PROVIDED HEREIN IS IN LIEU OF ALL OTHER
EXPRESS WARRANTIES, AND MAY NOT BE EXTENDED OR
MODIFIED BY ANYONE. ANY IMPLIED WARRANTIES SHALL BE
LIMITED TO THE PERIOD OF THE LIMITED WARRANTY AND
THEREAFTER ALL SUCH IMPLIED WARRANTIES ARE DISCLAIMED
AND EXCLUDED. THE MANUFACTURER SHALL NOT, UNDER ANY
CIRCUMSTANCES, BE LIABLE FOR INCIDENTAL, CONSEQUENTIAL
OR SPECIAL DAMAGES, SUCH AS, BUT NOT LIMITED TO DAMAGE
TO, OR LOSS OF, OTHER PROPERTY OR EQUIPMENT, LOSS
OF PROFITS, INCONVENIENCE , OR OTHER INCIDENTAL OR
CONSEQUENTIAL DAMAGES OF ANY TYPE OR NATURE. THE
LIABILITY OF THE MANUFACTURER SHALL NOT EXCEED THE
PRICE OF THE PRODUCT UPON WHICH SUCH LIABILITY IS
BASED.
This warranty gives you specific legal rights, and you may have
other rights which vary from state to state. Some states do not allow
limitations on duration of implied warranties or exclusion of incidental or
consequential damages, so the above limitations may not apply to you.
WARRANTY VALID IN CANADA AND MEXICO.
Maintenance Guidelines
Cleaning of Reservoir and Impeller:
1) Remove entire pump from wall, if mounted.
2) Disassemble reservoir from the deck by removing the four screws located at the corners of the deck.
3) Remove the impeller cover by loosening the five screws on the underside of the motor. Remove the impeller shaft
assembly.
4) Wipe off the gasket between the impeller & the motor housing with a damp cloth.
5) Reassemble impeller to the motor, then reassemble reservoir to the deck.
Cleaning of Check Valve:
1) Remove discharge line from valve.
2) Remove check valve with 9/16” wrench.
3) Visually check for obstructions or damage.
4) Replace valve by hand tightening, then tighten 1/2 turn with a 9/16” wrench.
Do not overtighten, damage to the O-ring seal may occur.
Servicing of a Double-Insulated Appliance
In a double-insulated product, two systems of insulation are provided instead of grounding. No grounding means
is provided on a double-insulated product, nor should a means for grounding be added to the product. Servicing a
double-insulated product requires extreme care and knowledge of the system, and should be done only by qualified
service personnel. A double-insulated product is marked with the words “DOUBLE-INSULATION” or “DOUBLE-INSU-
LATED”.