Spectra Precision Survey Pro v5.2 - Manual (Page 20)

12
Job Settings
The settings and values entered for a new job become the default values for any
subsequent new jobs. A short description of the jobs settings is given below.
• Units [1]: When creating a new job, set all the desired units for the job. You can
also enable the setting for Earth Curvature and Refraction correction for optical
measurements.
• Control File [2]: Control points can optionally be imported from another existing
job by checking the Use a Control File check box. After tapping Finish to create the
job, a message will indicate the number of imported points. If you are using a
control file, by default the coordinate system of this control file will be used for the
new job. You can override this default setting on the coordinate system page. A
control file can be imported from either a .Job or .Survey file.
[1] [2]
[3] [4]