Seed Hawk TOOLBAR 2015 - Manual (Page 51)

SEED HAWK ® 2015 TOOLBAR OPERATOR’S MANUAL 46
6.3 Wheel Hubs & Castor Plates
6.3.1 Main Frame Wheel Hubs & Castor Plates
6.3.2 Wheel Hubs
Lubricate Wing Castor DAILY to
ensure the smooth operation of. The
two fittings are on the upper and
lower castor wheel plates.
Lubricate Wing Wheel Hubs every
100 hours or annually. Lubricate Packer Wheel Hubs every
100 hours, or annually
.
Measure gap between castor wheel
plates and tighten castle nut every 100
hours. The gap should not exceed
1/8 in. (3mm). Adjust gap, if necessary,
by tightening castle nut on top of
castor wheel plate assembly.
Grease Fittings
Grease
Fitting
Castor Plate Gap
Lubricate main frame wheel hubs daily. Refer to Section 6.3.2 for hub grease
points.
Grease
Fitting