Seed Hawk TOOLBAR 2015 User Manual

Page 38

SEED HAWK

2015 TOOLBAR OPERATOR’S MANUAL 33

4.7.4 Furrow Depth & Width

4.7.3 Mud Scraper Adjustment

There is no adjustment to the
semi-pneumatic packer tire since
there is no air pressure. Ensure the
gap between the packer tire and the
mud scraper is minimal. Be sure to
check mud scraper setting before
seeding and yearly to ensure proper
gap between packer tire and mud
scraper.

For optimal mud clearance set the
mud scraper between 1/16 in. and
1/8 in. from the packer tire.

The knives are designed to place fertilizer ¾ in. (19mm) below and 1-½ in.
(38mm) to the side of the seed. Be sure to install, adjust and maintain knives
properly, in order to maintain these dimensions.

To adjust the depth of the fertilizer knife in relation to the seed knife:

1. Loosen hardware

2. Raise or lower fertilizer knife accordingly.

3. Tighten hardware.

Factory setting for fertilizer knife is: 20-7/8 in. (530mm) from the carbide tip to
the corner on the trip plate.

NOTE: Any damages sus-

tained to packer tires as a re-

sult of improper adjustment

or maintenance of scraper is

NOT covered by warranty.

20-7/8"
(530mm)